Author Topic: SCRUB: SpaceX Falcon 9 v1.1 - SES-8 - Nov. 25 - LAUNCH UPDATES (Read 110938 times)

Galactic Penguin SST · « **Reply #60 on:** 11/25/2013 09:36 pm »

New launch time 22:54 UTC.

Targeteer · « **Reply #61 on:** 11/25/2013 09:36 pm »

LOX stage vent had the anomaly

Chris Bergin · « **Reply #62 on:** 11/25/2013 09:37 pm »

Clock restarting. 22:54 ZULU T-0.

Prober · « **Reply #63 on:** 11/25/2013 09:38 pm »

Clock reset to T-19 mins.

then again reset to 17:24

Chris Bergin · « **Reply #64 on:** 11/25/2013 09:38 pm »

Targeteer · « **Reply #65 on:** 11/25/2013 09:38 pm »

spacecraft on internal power and go for launch

Chris Bergin · « **Reply #66 on:** 11/25/2013 09:40 pm »

Terminal Count at T-13 mins.

Targeteer · « **Reply #67 on:** 11/25/2013 09:41 pm »

polling at 13 minutes

Chris Bergin · « **Reply #68 on:** 11/25/2013 09:41 pm »

Polling is GO to continue with the terminal count.

Targeteer · « **Reply #69 on:** 11/25/2013 09:42 pm »

go to proceed with the count

Chris Bergin · « **Reply #70 on:** 11/25/2013 09:43 pm »

Pretty windy but acceptable for launch, as are upper level winds.

Chris Bergin · « **Reply #71 on:** 11/25/2013 09:44 pm »

Hold warnings for the countdown net, as per standard.

T-10 minutes.

Chris Bergin · « **Reply #72 on:** 11/25/2013 09:45 pm »

T-9 minutes.

Chris Bergin · « **Reply #73 on:** 11/25/2013 09:47 pm »

Unfortunate open mic somewhere.

T-7 mins. Nitrogen purge on the engines.

Chris Bergin · « **Reply #74 on:** 11/25/2013 09:48 pm »

ABORT!

Chris Bergin · « **Reply #75 on:** 11/25/2013 09:52 pm »

Wasn't an abort call over the net. The abort was confirmed on the loop. No reason given yet.

Prober · « **Reply #76 on:** 11/25/2013 09:52 pm »

corrodedNut · « **Reply #77 on:** 11/25/2013 09:53 pm »

"LOX load did not abort during terminal count"

russianhalo117 · « **Reply #78 on:** 11/25/2013 09:54 pm »

Wasn't an abort call over the net. The abort was confirmed on the loop. No reason given yet.

Computer system in charge of terminal count was cited in abort call

Chris Bergin · « **Reply #79 on:** 11/25/2013 09:54 pm »

Sequencer caused the hold. Vehicle being safed.