-
#260
by
Kel
on 17 May, 2009 17:03
-
A small sharp edge as a result of the broken bolt, but pressing ahead as normal. Shouldn't be a problem.
-
#261
by
ichilton
on 17 May, 2009 17:04
-
How far behind schedule are they?
-
#262
by
CzarB
on 17 May, 2009 17:04
-
I'm a little surprised there was no glove check after that.
-
#263
by
dotdk
on 17 May, 2009 17:04
-
I guess they will drop NOBL if time gets short?
-
#264
by
Kel
on 17 May, 2009 17:06
-
Taking some time to clean up extra tools before pressing ahead.
-
#265
by
Chris Bergin
on 17 May, 2009 17:07
-
"Mass, you've earned a bit of a break"
-
#266
by
orbitaldebris
on 17 May, 2009 17:08
-
Now that ACS part 2 is completed, would there be time in EVA 5 to install ALL of the NOBL's?
-
#267
by
Bubbinski
on 17 May, 2009 17:09
-
Here's a nice shot of the two Mike's:
-
#268
by
Kel
on 17 May, 2009 17:09
-
Next step to install FCP anchors, then the Fastener Capture Plate itself.
-
#269
by
Kel
on 17 May, 2009 17:12
-
-
#270
by
Kel
on 17 May, 2009 17:14
-
-
#271
by
Analyst
on 17 May, 2009 17:16
-
Now that ACS part 2 is completed, would there be time in EVA 5 to install ALL of the NOBL's?
EVA 5 is 5:45 nominal planned. So there is time. I wonder since day 1 why NOBL 5 is not in the nominal EVA plan with 45 minutes to spare.
Analyst
-
#272
by
Kel
on 17 May, 2009 17:17
-
One more fastener anchor to go before installing FCP
-
#273
by
MikeMi.
on 17 May, 2009 17:18
-
"Fastener Capture Plate is next"
-
#274
by
Kel
on 17 May, 2009 17:20
-
"Fastener Capture Plate is next"

-
#275
by
Kel
on 17 May, 2009 17:22
-
-
#276
by
MKremer
on 17 May, 2009 17:22
-
Sorry to interrupt the flow of the posts, but how come he is able to move so fast between sites? Shouldn't he be using the "always tethered" rule? I didn't see him using the tethers from the tool box back to telescope.
If you can redirect to a simple answer thanks!!
He is tethered. There are EVA tether guide wires above the sill of the payload bay on both sides. The primary reeled tethers of the free-floating person are hooked to that.
-
#277
by
rvmps
on 17 May, 2009 17:23
-
Thanks for the info!
-
#278
by
Kel
on 17 May, 2009 17:25
-
FCP wasn't seating properly - trying again. Thinks a gasket is interfering.
-
#279
by
Kel
on 17 May, 2009 17:27
-
Checking gasket on back side of FCP.
"Pretty stiff"