-
#120
by
Maty
on 17 May, 2009 15:05
-
Is that the capture plate I see?
Nope RIB caddy, have to remove handrail before plate can be installed
-
#121
by
Kel
on 17 May, 2009 15:06
-
Battery volt decay message.
Ready for mini power tool
-
#122
by
Maty
on 17 May, 2009 15:09
-
MPT in hand, RIB bit selected from the caddy
-
#123
by
Kel
on 17 May, 2009 15:09
-
Lost KU for about 15 minutes
-
#124
by
Maty
on 17 May, 2009 15:09
-
Lost KU, due back 25 after the hour
-
#125
by
Bubbinski
on 17 May, 2009 15:09
-
The astronauts have an amazing array of tools....here's some shots. TV lost from the shuttle, they'll get it back at 25 min after the hour.
-
#126
by
Kel
on 17 May, 2009 15:10
-
-
#127
by
Kel
on 17 May, 2009 15:11
-
-
#128
by
Kel
on 17 May, 2009 15:14
-
Elapsed time almost 1.5 hours
-
#129
by
Maty
on 17 May, 2009 15:15
-
Carefully selecting which retainers to install the washer retension clips. All installed, now removing the fasteners
-
#130
by
Kel
on 17 May, 2009 15:18
-
-
#131
by
AnalogMan
on 17 May, 2009 15:18
-
All four screws out, next to extract the washers held by the retaining clips using the WET (washer extraction tool) after passing RIB caddy to Bueno
-
#132
by
Maty
on 17 May, 2009 15:19
-
I have enough trouble removing c clips in 1g, let alone suited up in 0g. Better known around here as jesus clips, as in jesus where did that go.
-
#133
by
AnalogMan
on 17 May, 2009 15:21
-
OK, that went well - all four washers and clips removed.
-
#134
by
Kel
on 17 May, 2009 15:22
-
Washer and retention clips removed.
Remove fasteners on hand rail next.
-
#135
by
robertross
on 17 May, 2009 15:22
-
I have enough trouble removing c clips in 1g, let alone suited up in 0g. Better known around here as jesus clips, as in jesus where did that go.
We're a little more vocal in that respect...we call them 'JC' clips here...
-
#136
by
GoForTLI
on 17 May, 2009 15:23
-
Two more minutes until Ku.
-
#137
by
Kel
on 17 May, 2009 15:25
-
KU back
Working on removing hand rail
-
#138
by
Kel
on 17 May, 2009 15:27
-
Having trouble removing one of the lower bolts on hand rail.
"Doesn't look good"
"I don't think it's coming out"
-
#139
by
Maty
on 17 May, 2009 15:28
-
Little trouble seating the hex head into the fastener to undo it
